The official shape and proportions
Annex II of Regulation (EC) No 765/2008 defines the CE marking with a graduated drawing and requires that, if the marking is reduced or enlarged, the proportions of that drawing are respected. On its grid each letter is a ring with an outer radius of 10 units and an inner radius of 7 units, cut open by a vertical line 1 unit to the right of its centre. The centre of the E is 17 units to the right of the centre of the C, and the middle bar of the E is 3 units thick and ends 1 unit before the centre. The whole marking is 20 units high and 28 units wide, a ratio of 5 to 7. The generator draws exactly this construction.
Minimum size
Where the legislation for your product does not set other dimensions, the CE marking must be at least 5 mm high (Annex II, point 3). A 5 mm marking is 7 mm wide. Above that, any size is allowed as long as the proportions are kept.
How to affix it
- The CE marking is affixed visibly, legibly and indelibly to the product or its data plate. Where that is not possible or not warranted on account of the nature of the product, it goes on the packaging and on the accompanying documents (Decision No 768/2008/EC, Annex I, Article R12).
- It is affixed before the product is placed on the market. Where a notified body is involved in the production control phase, the marking is followed by the body's four-digit identification number.
- Only the manufacturer or its authorised representative may affix it, and only to products whose EU legislation provides for it (Article 30 of Regulation (EC) No 765/2008). Markings that could mislead about the meaning or form of the CE marking are prohibited.
- No colour is prescribed. Pick one that keeps the marking visible and legible on your product, whether it is printed, engraved or moulded.